爱普生230清零下截

Pens for Epson 230 reset cutoff to 700 words
一、准备工作
1. Preparation
1.1 常用工具：必须准备螺丝刀，跳线钳和十字螺丝刀等工具
1.1 Common Tools: Screwdrivers, Pliers, and Cross Screwdrivers must be prepared.
1.2 材料：你需要准备一个Epson 230钢笔，它是爱普生专用的钢笔，它有一个切断开关，用来重新设置计数器。
1.2 Materials: You need to prepare one Epson 230 pen, which is a special pen for Epson, it has a cutoff switch to reset the counter.
二、搭配螺丝刀完成清零
2. Use Screwdriver for Reset
2.1 找到Epson 230钢笔下方的螺丝位置，我们可以找到四个红色螺丝位置。
2.1 Find the screw positions under the Epson 230 pen, we can find four red screw positions.
2.2 将螺丝刀放到四个螺丝位置上，以移除此四个螺丝。
2.2 Put the screwdriver on the four screw positions to remove these four screws.
2.3 移开螺丝，可以看到钢笔上的数字滚轮和切断开关，调节数字滚轮和切断开关，来重设计数器，设置为700字。
2.3 Remove the screws and you can see the number roller and cutoff switch on the pen, adjust the number roller and cutoff switch to reset the counter and set it to 700 words.
2.4 将切断开关拉到上面，然后转动数字滚轮，直到滚轮上有700字，然后将切断开关拉回到原位，以完成爱普生230钢笔重新设置清零的程序。
2.4 Pull the cutoff switch up and then rotate the number roller until there are 700 words on the roller, then pull the cutoff switch back to its original position to complete the procedure of resetting the Epson 230 pen.
三、Pens for Epson 230 reset cutoff to 700 words完成
3. Completion of Pens for Epson 230 reset cutoff to 700 words
3.1 将螺丝重新放回钢笔上，拧紧螺丝，把Epson 230钢笔拿起来，看到钢笔上的数字显示的是700字，就说明清零成功。
【爱普生230清零下截】3.1 Put the screws back on the pen, tighten the screws, take up the Epson 230 pen and see that the number on the pen shows 700 words, which means that the reset is successful.